|
5.
How To
5.1
How to Use Echo SCU Service
-
Switch
to Echo SCU mode by either clicking on the ECHO SCU button in the
Mode window on the main window or by selecting Echo SCU from
the Modes menu.
-
Click
on CONFIGURE NODES button or select Nodes from the Configure menu to
bring up the DICOM Nodes dialog box.
-
If
you want to create a new node, click on the ADD button. The DICOM
Node Details dialog box will appear.
-
In
the DICOM Node Details dialog box, enter the Application Entity
Title, the port number that the system should use for sending the
request, the IP address of the node and the maximum PDU Size to be
used to negotiate when making an association request.
-
Click
on the Transfer Syntax tab to go to the Transfer Syntax page and
select the types of transfer syntaxes that will be supported by the
Echo SCU service.
-
Set
the calling AE Title using the General Configuration dialog box. It
will appear in the Calling AE Title combo box below the Mode window
on the main window.
-
Select
a called AE Title using the Called AE Title combo box in the main
window. Verify that the called AE Title corresponds to the node
displayed in the Node Name combo box. Note: There may be any number
of nodes with the same called AE Title.
-
Click
on the SEND button to make an echo request.
-
Interpret
the displayed information.
Return
to OT-DICE User Manual Table of Contents
OTech,
Inc., OT-DICE User Manual
Copyright © 2000 OTech, Inc.
All
rights reserved. |
